Automatic water pump EVN-A1100 (1100W)
Article: EVN-A1100
| Mains voltage | 170-220 V |
| Power | 1100 W |
| Throughput capacity | 92 l/min |
| Frequency | 50 Hz |
| Maximum pressure | 53 m |
| The diameter of the connection connector | 38 mm |
| Speed | 2860 rot/min |
| Suction depth | 8 m |
| Warranty | 12 months |
Automatic water pump EPA EVN-A1100 (1100 W)
This is an automatic surface pump that draws water from a well, tank or low-pressure pipeline and delivers it where needed at steady pressure. It starts by itself when a tap is opened, holds pressure through its tank once water use ends, and stops by itself. The 1100 W motor runs at 2860 rpm and delivers a flow of 92 L/min and a head of up to 53 m. It runs stably on a 170–220 V supply, so water delivery continues even where mains voltage drops.
Advantages
- 1100 W motor — a flow of 92 L/min and a head of 53 m serve systems with high water demand
- Suction from up to 8 m — draws water from a well or tank on its own, with no additional tank required
- Operation at low voltage (170–220 V) — keeps water supply running when the mains supply weakens
- Pressure tank — maintains constant pressure in the system and prevents frequent pump cycling
- Thermal relay — switches the pump off by itself when motor temperature rises, protecting it from burnout
- Check valve — passes flow in one direction only and stops water running back once the pump shuts off
- Cast iron housing with enamel coating inside — resists rust and lasts for years
- Full copper winding and brass impeller — improve durability and move water evenly
- Enlarged 38 mm connection diameter — carries a high flow without restriction
Application
Used in houses and country properties, gardens and irrigation systems to supply water and stabilise low pressure in pipework. With the highest output, flow and head in the series, it suits irrigation over large areas, multi-storey homes and small production sites; designed for clean water only — free of sand, clay and other solid particles.
Note on use
After installation the relay must be adjusted to the working water pressure, otherwise it may fail quickly. If the pipeline runs out of water, or in an emergency, the pump must be switched off immediately: dry running burns out the motor. Use with non-potable or waste water without a filter is not permitted.
EPA EVN-A1100 — a reliable automatic pump that draws water from a well or pipeline and delivers it at steady pressure.
Automatic water pump EPA EVN-A1100 (1100 W)
This is an automatic surface pump that draws water from a well, tank or low-pressure pipeline and delivers it where needed at steady pressure. It starts by itself when a tap is opened, holds pressure through its tank once water use ends, and stops by itself. The 1100 W motor runs at 2860 rpm and delivers a flow of 92 L/min and a head of up to 53 m. It runs stably on a 170–220 V supply, so water delivery continues even where mains voltage drops.
Advantages
- 1100 W motor — a flow of 92 L/min and a head of 53 m serve systems with high water demand
- Suction from up to 8 m — draws water from a well or tank on its own, with no additional tank required
- Operation at low voltage (170–220 V) — keeps water supply running when the mains supply weakens
- Pressure tank — maintains constant pressure in the system and prevents frequent pump cycling
- Thermal relay — switches the pump off by itself when motor temperature rises, protecting it from burnout
- Check valve — passes flow in one direction only and stops water running back once the pump shuts off
- Cast iron housing with enamel coating inside — resists rust and lasts for years
- Full copper winding and brass impeller — improve durability and move water evenly
- Enlarged 38 mm connection diameter — carries a high flow without restriction
Application
Used in houses and country properties, gardens and irrigation systems to supply water and stabilise low pressure in pipework. With the highest output, flow and head in the series, it suits irrigation over large areas, multi-storey homes and small production sites; designed for clean water only — free of sand, clay and other solid particles.
Note on use
After installation the relay must be adjusted to the working water pressure, otherwise it may fail quickly. If the pipeline runs out of water, or in an emergency, the pump must be switched off immediately: dry running burns out the motor. Use with non-potable or waste water without a filter is not permitted.
EPA EVN-A1100 — a reliable automatic pump that draws water from a well or pipeline and delivers it at steady pressure.














